noecoke Posted August 25, 2005 Share Posted August 25, 2005 Can anybody help me with my duo 2 se install. I used the diagram on their website on a v7 ps2. I used 30 awg kynar wire for everything except the ground and power points. I used 24 gauge wire there. Anyways, The ps2 turns on but all I get is a black screen. I checked to see if there was any leakage on the bios or solder points but everything is fine. Could it be a bad chip? I heard that maybe the ground wire is too long and that's why it doesn't work. Any tips on how to find out what's wrong with the install. Thanks in advance. Link to comment Share on other sites More sharing options...
Prican25 Posted August 26, 2005 Share Posted August 26, 2005 sounds like a bad ground connection, it is best that the power and ground wires are short as possible and for ground sake: best to use the copper ends of the motherboard as a ground, just scratch it up a bit so the solder can stick to it. Link to comment Share on other sites More sharing options...
noecoke Posted August 27, 2005 Author Share Posted August 27, 2005 Are there any closer alternative ground and power points besides the one on the official duo se 2 website diagrams. The power point goes from one end of the board to the other. thanks. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now